First of all, I know that this is a ‘first world problem’ and in the big scheme of things, trying to improve how and where we charge all our electronics is not a big deal. Still, it was a fun project that I made with some scrap that I found in my wood pile so I figured I would share.
The need for a better way to organize our charging area became apparent while walking past it last weekend. I noticed that with two iPads and two iPhones, we end up just laying them all out on the counter and when they are all connected, it takes up a significant amount of counter space and just doesn’t look as organized as my mind likes to keep things.
Julie bought me our existing charging station for Christmas or a birthday a few years ago. It consists of a drawer and a hollow area for a power strip below a top that has slots for devices to rest. The problem is that you can’t put iPads on it and because of that, and the need to pull the charging cables out really far to reach the iPads, no devices end up actually on the charging station.
I thought if I could find a relatively small piece of wood and cut some angled slots in, it might do just the trick and be free! I did a little googling and found out that I was not alone in this line of thinking. Lots of different ideas similar to this are out there, but since it’s so simple there is little you get from seeing what others have done.
I took a piece of 1×6 oak I had lying around, cut it to 14″ and got started. I needed to cut four slots with enough space in-between to allow for them to sit at an angle. The table saw was the logical tool to make the cuts since they needed to be angled and precise. I laid out the design on the block of wood, set the angle of the blade to 12 degrees (I wanted the devices to angle a little, but remain mostly upright), and got cutting.
The only real piece of advice on this was to GO SLOW and have all your devices on hand. I made my stand custom for each devices width, including the case. This is one of the major benefits over buying a prefabricated stand. I took the exact device and test fit it as I was cutting my grooves. Most stands have a fixed width which may not fit your device while it’s in the case. Some stain, two coats of poly, and it’s done.
End result, not bad… not bad at all, and we now have our counter back.
Leave a Reply